Three phase motors fitted with electromagnetic springloaded
Fail-Safe DC brakes. Enhanced performance cast
aluminum IEC frame with Design B torque characteristics.
Features a multi-mount arrangement incorporating bolt on
feet with flange mount configurations available. 2, 4 and 6
pole, 0.09 to 7.5kW.
Motor Features
STANDARD FEATURES
Removable feet F1, F2, F0 field convertible
1.15 Service Factor
36 Month warranty
Conduit Box is 90º rotatable
B5/B14 and increase/decrease flanges available
Anti-microbial (tropicalization) on stator winding
1045 Steel shaft
Surface finish:
Alkyd enamel RAL7024 - Graphite Gray
Black oxide surface treatment for increased corrosion resistance
Stainless steel nameplate
Corrosion resistant hardware
Metric threaded cable gland included with motors
Normally closed brake
Bridge rectifier used for AC to DC conversion, located inside motor terminal box
Standard with full-wave rectifier and 205VDC brake
6-Lead 575V wye connection
Standard with half-wave rectifier and 250VDC brake
Motors fitted with standard IEC marked terminal block
Dual rated motors pre-wired High Voltage
INGRESS PROTECTION
The standard degree of motor enclosure protection is IP55
(increased IP protection is available). Brake mechanical
components rated IP23. Both drive end and non-drive end are
fitted with double lip oil seals, including a rubber shaft slinger
on the drive end. Terminal box is double gasketed. DE/NDE end
bell fitted with sintered brass one-way drain.
INSULATION AND INVERTER RATING
Class F Insulation (Impregnation resin, magnet wire and insulation materials are Class H)